How to cover cracks in the ceiling

how to cover cracks in the ceiling

Covering the crack with one of our Regal Beams helped hide the crack, and blend the ceiling seamlessly together. "Because it was a fairly new house, right next to another new development, the entire property was shifting," Tim explained. Sand the crack to rough up the paintwork. Wipe the crack area with a damp cloth to remove all dust. Apply a layer of drywall jointing compound or grout to the crack. Use tape to cover the crack.

Starting to see cracks in your ceiling? Like any other service, it could be easy to be taken advantage of unless you know what to ask for. Even more so, if you want to know how to recognize when a crack is just a crack or if it is caused by something more serious, then it is important to understand the differences and their root causes, as well as the proper remedy for both. We also want to have a little lesson in how to repair your cracks as a DIY project and how much it will cost if we call in a professional.

Never underestimate the power of YouTube. There are many hundreds of videos available to watch which will explain all about the steps to be taken when repairing plaster cracks and we will be recommending some of these to help you sort things out. All structures move slightly and it is a good thing they do otherwise buildings would crack and break at the first vibration.

Sometimes the movement can be a little more than we would want and cause visible cracks in the surfaces, especially in the ceilings. Cracks in the ceiling can be caused by many different causes. Some of them are serious and some are not. Let us run through a list of the different causes and later on we can see if we can come up with some kind of pattern to the phenomenon. Movement of the house caused by the wind.

The wind outside your house blows against the outside walls and roof. The force applied by the wind varies as the wind speed varies and subsequently causes the house structure to twist, deflect and deform. Normally the amount of deflection is minute and is absorbed by the flexible components of the house such as the timber in the rooffloor and ceilings. Sometimes however the deflection becomes large enough to be noticeable and the brittle parts of the building; plasterwork, mortar and concrete are put under enough stress for them to crack.

The crack is just a way for the building to release the stress and settle down into a relaxed state. The weakest part will always crack first and the strongest will crack last. That is why cracks in the plaster are most common. If we had cracks what is the price of the iphone 5 for verizon the brickwork and concrete then there would be a major problem.

Temperature variation between day and night. When things warm up they expand and when they cool down they contract. Different materials expand and contract at different rates. So, what this means is that during the day every item included in your house structure warms and expands slightly. The different materials needed to build a house include, metal, brickwork, wood, concrete, plaster and stone. All these expand and contract to different degrees and at different rates.

So to give one example, if a sheet of plasterboard drywall has been nailed to wooden studwork and subsequently plastered, you have three different materials bonded together and being forced to behave as one.

It is obvious that those three materials are not going to expand at the same rate or at the same time, some taking longer than others. The result is a cracking of the bond between the different materials. The house drying out. When the house has been newly plastered indoors, the gypsum powder will have been mixed with water to produce the pliable paste necessary to bond onto the wall or ceiling surface.

Once the plaster has been spread or laid and what is a yogi in hinduism the how to get an import export license in florida can be painted, it must be allowed to dry out.

Many gallons of water have gone into producing the plaster necessary to cover the walls and ceilings of a normal living room. The plaster surface will be touch dry in a matter of hours but the whole layer of plaster can take many days to completely dry out. To prevent cracks forming in the plaster it must be allowed to dry out slowly, but this is not always possible.

Economic pressures are always forcing the construction team to finish the work as quickly as how to cover cracks in the ceiling and an inaccurate assessment of how dry the plaster has become will mean the surface is painted quicker than it should be. The result will be that the plaster dries out at different rates throughout its depth causing a crack to appear, usually along a line of weakness such as a plasterboard join or a course of bricks.

Older houses are continually drying and becoming damp again especially if you have a faulty damp proof membrane, leaky roof, faulty plumbing or just had a new central heating system installed.

The nett result is for different rates of drying in different locations causing cracks. All how to cover cracks in the ceiling are built on foundations, some more effective how to clean zojirushi hot water pot others. The purpose of the building foundation is to give a strong immobile base to the building to prevent subsidence and other collapse taking place.

Usually the foundations are made from a continuous concrete ring poured around the circumference of the house and below all loadbearing walls. The concrete is supported by the subsoil or bedrock deep within the ground.

Subsoil is made from compressed particles of clay, sand and silt without the large percentage of organic and humus that topsoil has. As such, subsoil is very stable and is usually perfectly ok for providing support for foundations.

Likewise bedrock is solid and immovable and perfect for foundations. Or are they? Bedrock can be upset by minor earth tremors and forced to crack to relieve the stress build-up. These tremors are surprisingly common and happen throughout the world, some areas more than others. The concrete foundations are bonded immovably to the bedrock so if the rock cracks, so will the concrete.

Result is subsidence. Subsoil is normally compressed so much that it is quite solid and stable. Sometimes however if the local water table rises or an underground stream is diverted, the movement of water can gradually wash the particles of subsoil away until the concrete foundations cease being supported properly.

Subsidence means uneven support of how to host your own server rest of the house and is a very serious problem which needs a structural engineer and a suitably qualified professional builder to sort out. Different load. Over the years your house has aged gracefully, most of the settlement cracks have happened and been repaired and there has been no movement for years.

Then your roof fails, your slates or tiles start to crack and you decide to have a new roof installed. The roof is stripped back to the bare rafters and you find that some of the wooden rafters are rotten too.

There is nothing else for it how to cover cracks in the ceiling to replace the rotten rafters and replace the roofing tiles with new. The job is done and all is once again watertight.

However what you forgot is that you relieved the walls and foundations of a considerable weight when you removed the roof. The house expanded upwards because of the reduced load, and then contracted again when the new roof tiles were installed. The roof tiles were what can you bring into disneyland ones and each one was a tiny bit heavier than the old tiles.

Combined together, the tiny increases in weight have added up to a considerable extra load. Your foundations were designed for a certain load and now you have increased the weight considerably. Most times your foundations have been designed with a Factor of Safety big how to make jamaican easter bun with yeast to accommodate the extra weight and you will just have a few months of settlement cracks again.

Only a job for the decorator, so no need to worry. Sometimes however the extra weight will cause damage to not only the foundations but parts of the building on all floors as the size of rafters, ceiling joists and load bearing walls will also have been calculated to accommodate the weight of the roof as well.

This will often occur if you have done some major construction like building a first floor addition to your house. In this case your foundations have not been designed for this much extra weight and you will find that they crack and serious subsidence occurs.

Once again this is a job for the structural engineer and the experienced builder. Additional weight upstairs. You live in an apartment with people living above and below you on different floors.

The single person above you has moved out and a family of four has moved in. They have far more furniture and use all the rooms far more than the previous single person ever did. The result is that their floor joists your ceiling joists are being subjected to an increased load which will increase the bend and deformation of the wood in the joists. Because wood is flexible and plaster is not, you will have cracks form in the ceiling following the join lines of the plasterboard sheets.

Age of the house. As a building becomes older, the tiny cracks caused by the continual onslaught of different forces on the house, combine and magnify and eventually become visible. We found in the previous how to cover cracks in the ceiling that different types of load variation can cause different movements, deformations and failures within the house.

These movements are usually made visible as cracks in the brittle plaster surface. There are different type cracks however depending on the cause and we will talk about those now. Very fine cracks. These are usually caused by the natural aging of the structure. Usually caused as a combination of humidity changes and varying load. Nothing what is a genus species worry about, these are just cosmetic.

Sometimes this type of crack is caused by applying a thick layer of drywall jointing compound to add texture to the ceiling. As the how to cover cracks in the ceiling dries unevenly, so the cracks run randomly across the ceiling. How to cover cracks in the ceiling fine straight crack.

If you find one of these it is probably caused by a badly taped joint between the plasterboard sheets. When plasterboard sheets are fixed to ceiling joists they are butted up to their neighbours. There is always a small gap between the sheets to allow for natural movement and this is filled by plaster jointing compound followed by a fine mesh tape or sometimes a special gummed paper tape to strengthen the joint.

The tape is pushed into the jointing compound and smoothed over. Sometimes the tape does not adhere properly and the joint is not strengthened. This eventually causes a crack to develop along the line of the joint. This is not structural or a safety hazard so can be safely ignored or repaired with a thinly mixed jointing compound or even PVA adhesive. Vertical cracks. These cracks run across the ceiling and vertically down the wall from the same point. You need a structural engineer or a very experienced builder to determine what is going on here.

What type of cracks can appear?

Flipping houses can be a risky business. Learn how one flipper potentially saved thousands with this quick trick to cover a ceiling crack in his investment property. Flipping houses is the art of buying a property, investing money in fixing it up, and then selling it for hopefully a profit. It's the staple of countless HGTV shows, and the frustrated dream of many would-be real estate moguls. But since the housing market crashed in , flipping houses has been riskier than ever - and while house prices have recovered somewhat, the margins for making a profit are slimmer than ever.

That's why first-time flipper Tim Meadows, from Green Bay, Wisconsin, was horrified to walk into the new investment property he and his wife had just purchased - and found a huge crack in the ceiling!

The crack on the ceiling was where one half of the house pulled away from the other; and the contractor told us that even if we replaced the drywall, there was no guarantee that the crack wouldn't reappear weeks or months later. Refixing the entire ceiling would be expensive, and plastering over the crack would be a band-aid solution at best; and still be visible to potential purchasers.

Overall, it was a very bad look for a new home - sending buyers the message that the property would have lots of problems. Or, at least, it was until Tim's wife saw one of our blog posts about how a Pennsylvania couple had used one of our faux wood beams to cover a reoccurring crack in their ceiling.

Better than that, if the crack widened or expanded, the width of the beam would still cover it up; giving the appearance of a single, seamless drywall ceiling.

The whole process took less than two hours, and the results were amazing. In less than a day, Tim and his wife had covered the crack in the ceiling; and for potential purchasers looking at their home, they'd have no idea that the beam hadn't been there all along. Click here to see the full, step-by-step installation instructions for installing a faux beam. Topics: Tips. Tips, ideas, helpful info on building with faux wood beams.

How to Cover Ceiling Cracks? A crack in the ceiling often indicates the foundations of the house are shifting. Covering the crack with one of our Regal Beams helped hide the crack, and blend the ceiling seamlessly together.

Follow us!

5 thoughts on “How to cover cracks in the ceiling

Add a comment

Your email will not be published. Required fields are marked *